Kanalna bakrena zbiralka

A channel copper busbar has a U-shaped cross-section: two parallel sides joined by a flat bottom, like a slot or channel profile. The shape is made to contact two conductive surfaces at once - the two parallel legs can clamp over an existing busbar or bridge between two terminals, roughly doubling the contact area of a single flat bar and lowering joint resistance and heat. The dimension that matters most is the spacing and parallelism between the two sides; if they drift, the channel will not slip over the mating part. We bend with dedicated fixtures that hold the material square during forming and measure width and side alignment on every piece, holding the bottom corner radius so the copper does not crack. Material is T2 copper to GB/T5585.1-2026, Cu >= 99.90%, >= 97.3 % IACS.

AU-kanal deluje samo, če se dejansko prilega čez palico, ki naj bi jo vpenjal, kanal, ki se veže do polovice, pa zahteva predelavo na tekočem traku. Naše upogibne napeljave držijo obe strani vzporedni in med oblikovanjem zaklenejo razmik med--stranami, to širino in poravnavo pa preverimo na vsakem kosu namesto vzorčenja. Prednost pri nakupu je predvidljivo prileganje reži: kanal zdrsne čez vašo soparno zbiralko v prvem poskusu, brez podložkov ali prisilne namestitve, ponovna širina po naročilu pa pomeni, da gre vsak sklop skupaj na enak način. Pred{6}}proizvodni vzorec vam omogoča poskusno-namestitev kanala na svoj del pred množičnim rezanjem.